| |
|
 |
|
 |
|
Prasad GWK CoolTech : |
| |
Mould Dehumidifier
(Capacity: 1000 M3/hr
to 2000 M3/hr)
Most molded products, whether injection molded, blow
molded or vacuum formed (thermoformed) products are
cooled by chilled water in mold cavities. The cooling
time, which normally is the longest part of the total
cycle time and the molding process, is an expensive and
an important part of the manufacturing process.
Lowering the chilled water temperature in the mold leads
to a shreter cycle time.
Requirement of Process
To have dry air at lower temperature than the ambient
temperature at desire flow to prevent mold sweating on
mold surface.
Advantage
Reduce cycle time and avoid mould sweating.
|
|
|
|
|
|
)
